| Subject | Text |
| 27f-s50 sharp 27 inch rear case (cabinet) shattered | i've tried to search for this part and they all say it is unavailable. my question is can i use anot |
| How to choose the auto dry cabinet? | The purchase advice:
(1) Auto dry cabinet is a special product and has particular demand for re |
|
|
| 27f-s50 sharp 27 inch rear case (cabinet) shattered | --------------------------------------------------------------------------------
i've tried to s |
| Plasma TV Lift Cabinet - Lift Won't Rise - Troubleshooting | Hello All,
I have a Plasma/LCD TV lift / popup cabinet from an unknown manufacturer. I was working |
| How to choose the auto dry cabinet? | 1. The problem leaded by not appropriate choosing and using the auto dry box
......
2. The |
| Magnavox MDR700 under cabinet kitchen TV | Does anyone have a source for the subject schematics or has perhaps fixed a dead unit?
Thanks :( |
| Dell p991 | I need the procedure to open the p991 cabinet, my monitro nurned out and i could only buy a white on |
| I had exactly the same symptoms on my 10 year old Sharp TV. The last time it happened, hitting the c |
| Re: magnavox computer vdu | [quote:134e5a9605="techguy"]from techguy. suspect a component(an electrolytic capacitor?)may ha |
| PHILIPS TELEVISIONS LED AND MODEL NUMBERS | HI ALL
THIS IS INPORTANT WHEN POSTING FAULTS FOR PHILIPS TELEVISIONS,ALWAY POST THE MODE |
| My 50707 just went to the shop after it would go into protection mode, worked over a weekend, and th |
| :) Okay: lots of folks experience these type of problems after a move. and they do just what you did |
| It like flickers and shakes until I hit it on the right side or move the cabinet then it stops. Hol |
| Picture squeezes horizontally | Make and model of set would normally be required for more detailed diagnosis.
With the set unplugge |
| Electronics removal | HI, I'm new and have a simple question. I have a very nice 25' GE console tv (25pm5888p) that no l |
| Like I mentioned, based on previous experience with Sony, the part that you need (the face) is usual |
| Shocking Panasonic TX-21S1T | I knew I saw the recall notice. I pasted it below.
For your attention: ELECTRIC SHOCKS FROM NEW T |
|
|
| By the way, for anyone else who has this problem, here's the part numbers I ordered:
[b:5d588c8aa |
| [quote:413dc9db9f="jts1957"]You really should learn how to use a search engine.
You didn't indica |
| You've disassembled it far enough to see into the dark, obscured corners of say, the Front circuit b |
| Hitachi 51S500 "dry joint" problem? Please help! | Picture will go from great, to slightly splotchy, or gross red streaking, or just black. Sound rema |
| Hello,
In my point of view Transtronics Inc Pocket Programmer 2 is the best Eprom copier.
Tha |
| Error code | C 0910 =2nd Drawer Paper Lift-up Failure
C 0d50=Duplex Unit Drive motor M31`s Fail to Turn
C 0F20= |
| Sony TV KV-27510 | TV has worked fine all these years and now picture turns light blue, then you hit the side of the ca |
| Hitachi Plasma Model Number:- 42PMA225EZ Dead! | Can anybody please advise on a friends Hitachi 42" Plasma Model Number 42PMA225EZ which died sh |
| Zenith pvy5265 | Well story short......I had a dead RCA 52inch chassis, power supply blown after power surge with mul |
| It depends on your interior situation and design. Generally TV Lift have not require any assembly fu |
| PHILIPS TV LED CODES | HI THERE
HAS WITH MOST TV THAT USES A LED INDICATOR ON MODERN SETS,WHEN THESE LEDS BL |
| check on right hand side pcb mounted on side of cabinet. |
| Bosch Fridge/Freezer Not Working | I had this problem with my Bosch Fridge/Freezer. The compressor was receiving half-wave rectified a. |